Indoor/Outdoor Water-Resistant Adhesive For Synthetic Turf

Condition the area to be installed.  Make sure adhesive and surfaces are at 45°F (7°C) or above for 48 hours before, during and 48 hours after installation. Surfaces must be sound, smooth, dry, clean and free of excessive moisture or alkali. Remove dirt, wax, loose paint and all other foreign matter that would interfere with a good bond such as curing agents and sealers.  If using seam tape/binder material, make sure it is free of debris before applying the adhesive.

• Stir any liquid on the surface into the adhesive.
  
• Full spread adhesive using recommended 1/8" trowel
• NOTE: Recommended trowel sizes are guidelines only, and are minimum requirements. Rough, porous concrete and heavily textured carpet backings may require deeper notches. A 100% transfer of adhesive into the carpet backing, while maintaining full coverage of the substrate, must be obtained.
  
• Install carpet into wet adhesive. Do not let adhesive skin over.
  
• Within 30 minutes, cut, fit and reposition as recommended by the carpet manufacturer. Lift a newly laid area occasionally to make sure adhesive is transferring to back.
  
• Smooth the bonded area with firm pressure using a 2-foot length of carpet tube. It is essential to use a light roller for polypropylene-backed carpets. Avoid squeezing adhesive up at the seams. Remove any ozzing wet adhesive with a clean, white cloth dampened with soapy water.  Do not allow this unwanted adhesive to dry because it is yellow/orange in color and your seams will not look good!